当前位置: X-MOL 学术Surf. Innov. › 论文详情
Our official English website, www.x-mol.net, welcomes your feedback! (Note: you will need to create a separate account there.)
Mn (IV) oxide/Mn (IV) sulfide/poly-2-amino-1-mercaptobenzene for green hydrogen generation
Surface Innovations ( IF 3.5 ) Pub Date : 2023-10-23 , DOI: 10.1680/jsuin.23.00031
Mohamed Rabia 1 , Asmaa M Elsayed 2 , Maha Abdallah Alnuwaiser 3
Affiliation  

A manganese (IV) oxide (MnO2)–manganese (IV) sulfide (MnS2)/poly-2-amino-1-mercaptobenzene (P2AMB) nanocomposite is prepared through a polymerization reaction (oxidation) and is utilized as a highly photo-electrocatalytic material for green hydrogen generation from sewage water. The manganese (IV) oxide–manganese (IV) sulfide/P2AMB nanocomposite demonstrates remarkable optical properties, characterized by a band gap of 1.81 eV. To promote the water-splitting reaction by the synthesized manganese (IV) oxide–manganese (IV) sulfide/P2AMB nanocomposite photoelectrode, sewage water is utilized as a sacrificial agent to facilitate effectively the generation of hydrogen gas through the evaluation of the current (J ph). At −0.9 V, the J ph and J o values are determined to be −0.33 and −0.2 mA/cm2, respectively. Notably, an optimum J ph value of −0.26 mA/cm2 is observed for incident photons at 340 nm, indicating that light with higher frequency and energy leads to the generation of more electrons from the manganese (IV) oxide–manganese (IV) sulfide/P2AMB nanocomposite and subsequent hydrogen production. Conversely, the lowest J ph value of −0.21 mA/cm2 is obtained at 730 nm, suggesting the influence of infrared waves on the photoelectrode due to the small band gap (1.86 eV) of the materials, as calculated in a previous analysis. This study represents an initial step toward the conversion of wastewater into hydrogen gas, which can serve as a sustainable fuel source for various industrial applications.

中文翻译:

用于绿色氢产生的氧化锰(IV)/硫化锰(IV)/聚-2-氨基-1-巯基苯

通过聚合反应(氧化)制备了氧化锰(IV)(MnO 2)-硫化锰(IV)(MnS 2)/聚-2-氨基-1-巯基苯(P2AMB)纳米复合材料,并用作高光敏材料-用于从污水中产生绿色氢的电催化材料。氧化锰 (IV)-硫化锰 (IV)/P2AMB 纳米复合材料表现出卓越的光学性能,其带隙为 1.81 eV。为了促进合成的氧化锰(IV)-硫化锰(IV)/P2AMB纳米复合光电极的水分解反应,利用污水作为牺牲剂,通过评估电流(J 酸碱度)。在-0.9V时,J phJ o值分别确定为-0.33和-0.2 mA/cm 2。值得注意的是,对于 340 nm 的入射光子观察到最佳J ph值为 -0.26 mA/cm 2 ,这表明具有更高频率和能量的光会导致从锰 (IV) 氧化物-锰 (IV) 产生更多电子硫化物/P2AMB纳米复合材料和随后的氢气生产。相反,在730 nm处获得-0.21 mA/cm 2的最低J ph值,这表明红外波对光电极的影响是由于材料的带隙小(1.86 eV),如之前的分析计算的。这项研究代表了将废水转化为氢气的第一步,氢气可以作为各种工业应用的可持续燃料来源。
更新日期:2023-10-23
down
wechat
bug