当前位置:
X-MOL 学术
›
IEEJ Trans. Electr. Electron. Eng.
›
论文详情
Our official English website, www.x-mol.net, welcomes your feedback! (Note: you will need to create a separate account there.)
All Ceramic Ion Sensor Using Dielectric BaTiO3 Transducer
IEEJ Transactions on Electrical and Electronic Engineering ( IF 1 ) Pub Date : 2024-03-08 , DOI: 10.1002/tee.24053 Soichiro Suzuki 1 , Satoko Takase 1 , Youichi Shimizu 1
IEEJ Transactions on Electrical and Electronic Engineering ( IF 1 ) Pub Date : 2024-03-08 , DOI: 10.1002/tee.24053 Soichiro Suzuki 1 , Satoko Takase 1 , Youichi Shimizu 1
Affiliation
An all‐solid‐state impedance metric hydrogen‐phosphate ion sensor device has been tried to fabricate using BaTiO3 as a transducer and spinel‐type oxide receptor. AC impedance measurement was carried out using flow‐cell system with boric‐acid buffer solution with hydrogen‐phosphate ion The Co2 RhO4 /BaTiO3 sensor device was found to show impedance responses to hydrogen‐phosphate ion at 5 × 10−4 M and 1.0 × 10−2 M with the 90% response time of ca. 150 s. The Co2 RhO4 /BaTiO3 device showed good response characteristics among the tested devices in terms of sensitivity and restoration rate. © 2024 Institute of Electrical Engineer of Japan and Wiley Periodicals LLC.
中文翻译:
采用电介质 BaTiO3 传感器的全陶瓷离子传感器
尝试使用 BaTiO 制造全固态阻抗测量磷酸氢盐离子传感器装置3 作为传感器和尖晶石型氧化物受体。交流阻抗测量是使用流通池系统进行的,其中硼酸缓冲溶液含有磷酸氢根离子2 铑4 /钛酸钡3 传感器装置被发现对磷酸氢盐离子在 5 × 10 处表现出阻抗响应−4 米和1.0×10−2 M 的 90% 响应时间为约 150 秒。公司2 铑4 /钛酸钡3 设备在灵敏度和恢复率方面在测试设备中表现出良好的响应特性。© 2024 日本电气工程师协会和 Wiley periodicals LLC。
更新日期:2024-03-08
中文翻译:
采用电介质 BaTiO3 传感器的全陶瓷离子传感器
尝试使用 BaTiO 制造全固态阻抗测量磷酸氢盐离子传感器装置