Abstract—
The aim of this study is an experimental-based analysis of the effect of surface treatment, leading to the formation of carbonized layers, on the coefficient of sliding friction of two polyurethane materials that differ in mechanical and rheological properties. The properties were determined by the results of indentation on a NanoScan-4D scanning nanohardness tester. A ceramic ball with a diameter of 2.1 mm was used as an indenter, which was pressed into the samples at a given linear velocity. The indentation curves at low and high indentation velocities were used to calculate the longitudinal and instantaneous reduced modulus of elasticity. It was found that the longitudinal elastic moduli differ by more than seven times, and the rheological properties of a more rigid material are weak. Tribological tests were performed on a UMT-3 friction machine in the mode of unidirectional sliding friction at a constant load and velocity. Based on the data, regression equations were calculated and the dependences of the friction coefficient on the load and sliding velocity were obtained. The influence of the surface treatment fluence on the surface roughness, adhesion, and deformation friction force is analyzed, data are correlated with the known experimental and theoretical results. It is shown that surface treatment with a relatively small fluence gives fundamentally different effects for the two studied materials: a slight change in roughness and decrease of friction coefficient for the more rigid polyurethane; a significant increase in roughness and a consistently high coefficient of friction, which varies slightly in the considered ranges of loads and velocities. Thus, surface treatment can be used for controlling the coefficient of friction of polyurethane and ensuring its consistently high frictional properties.
REFERENCES
Kislitsyn, V.D., Shadrin, V.V., Osorgina, I.V., and Svistkov, A.L., Analysis of the mechanical properties of polyurethane materials manufactured by mortar and injection technology, Vestn. Perm. Univ., Fiz., 2020, no. 1, pp. 17–25.
Chudinov, V.S., Shardakov, I.N., Svistkov, A.L., and Kondyurin, A.V., Polyurethane modified by plasma ion implantation, in NANOCON 2018, Conference Proceedings, Ostrava: TANGER, 2019, pp. 295–299.
Torskaya, E.V., Stepanov, F.I., Tsukanov, I.Y., and Shkalei, I.V., Sliding contact of coated viscoelastic solids: Model and experiment, J. Phys.: Conf. Ser., 2020, p. 012033.
Hausberger, A., Major, Z., Theiler, G., and Gradt, T., Observation of the adhesive- and deformation-contribution to the friction and wear behaviour of thermoplastic polyurethanes, Wear, 2018, vols. 412–413, pp. 14–22.
Sato, S., Yamaguchi, T., Shibata, K., Nishi, T., Moriyasu, K., Harano, K., and Hokkirigawa, K., Dry sliding friction and wear behavior of thermoplastic polyurethane against abrasive paper, Biotribology, 2020, vol. 23, p. 100130.
de Vries, E.G., van Minnen, B.S., Wu, Yi., and Matthews, D.T.A., and van der Heide, E., Tribological behaviour of a synthetic synovial fluid and polyurethane in biomedical implants, Biotribology, 2023, vols. 33–34, p. 100242.
Johnso, K.L., Contact Mechanics, Cambridge: Cambridge Univ. Press, 1985.
Bukovskiy, P.O., Morozov, A.V., and Kirichenko, A.N., Influence of running-in on the friction coefficient of C/C composite materials for aircraft brakes, J. Frict. Wear, 2020, no. 4, pp. 326–332.
Fuller, K.N.G. and Tabor, D., The effect of surface roughness on the adhesion of elastic solids, Proc. R. Soc. London, Ser. A, 1975, vol. 345, pp. 327–342.
Purtov, J., Gorb, E.V., Steinhart, M., and Gorb, S.N., Measuring of the hardly measurable: Adhesion properties of anti-adhesive surfaces, Appl. Phys. A, 2013, vol. 111, no. 1, pp. 183–189.
Guduru, P.R., Detachment of a rigid solid from an elastic wavy surface: Theory, J. Mech. Phys. Solids, 2007, vol. 55, no. 3, pp. 445–472.
Kesari, H. and Lew, A.J., Effective macroscopic adhesive contact behavior induced bysmall surface roughness, J. Mech. Phys. Solids, 2011, vol. 59, no. 12, pp. 2488–2510.
Goryacheva, I. and Makhovskaya, Y., Adhesion effect in sliding of a periodic surface and an individual indenter upon a viscoelastic base, J. Strain Anal. Eng. Des., 2016, vol. 51, no. 4, pp. 286–293.
Morozov, A.V. and Makhovskaya, Yu.Yu., Experimental and theoretical evaluation of the deformation component of the coefficient of friction, J. Frict. Wear, 2007, vol. 28, no. 4, pp. 331–337.
Torskaya E.V. and Stepanov F.I., Effect of surface layers in sliding contact of viscoelastic solids (3-D model of material), Front. Mech. Eng., 2019, vol. 5, p. 26.
Funding
This study was supported by the Russian Science Foundation, project no. 18-19-00574.
Author information
Authors and Affiliations
Corresponding author
Ethics declarations
The authors declare that they have no conflicts of interest.
About this article
Cite this article
Shkalei, I.V., Torskaya, E.V. Effect of Ion-Plasma Surface Treatment on Tribological Characteristics of Polyurethane. J. Frict. Wear 44, 253–258 (2023). https://doi.org/10.3103/S1068366623040098
Received:
Revised:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.3103/S1068366623040098