Skip to main content
Log in

Effect of Wind Velocity on Smoldering Ignition of Moist Pine Needles by a Glowing Firebrand

  • Published:
Fire Technology Aims and scope Submit manuscript

Abstract

Firebrand ignition of wildland fuels is an important pathway of initiation and propagation of wildland and wildland-urban interface fires. The ambient wind plays an important role in smouldering ignition of wildland fuels by firebrands, but its influence is poorly stated. In this work, the effect of ambient wind on the ignition of a moist pine needle fuel bed by a glowing firebrand was investigated. Two ignition outcomes, smouldering or failed ignition, were observed. Wind was found to have a significant impact on the ignition process by affecting the glowing combustion state of the firebrand. As the wind velocity increased from zero to 4 m/s, the smouldering ignition probability firstly increased and then decreased, while the smouldering ignition delay time decreased. Under the same wind conditions, the ignition probability decreased while the smouldering ignition delay time increased as the fuel moisture content increased from 5.9% to 53.2%. A theoretical model based on the glowing combustion rate of firebrand and heat transfer between the firebrand and the fuel bed under the effect of wind was proposed. The model predicted the variation trend of the smoldering ignition delay time with the wind velocity well when FMC was less than 20%, but poor at higher FMC. It also predicted that the square root of ignition delay time had a good linear relationship with FMC. This work is a step forward in understanding of spot fires initiated by glowing firebrands.

This is a preview of subscription content, log in via an institution to check access.

Access this article

Price excludes VAT (USA)
Tax calculation will be finalised during checkout.

Instant access to the full article PDF.

Figure 1
Figure 2
Figure 3
Figure 4
Figure 5
Figure 6

Similar content being viewed by others

References

  1. Bowman DM, Williamson GJ, Abatzoglou JT, Kolden CA, Cochrane MA, Smith AM (2017) Human exposure and sensitivity to globally extreme wildfire events. Nat Ecol Evol 1:0058. https://doi.org/10.1038/s41559-016-0058

    Article  Google Scholar 

  2. Hammer RB, Radeloff VC, Fried JS, Stewart SI (2007) Wildland-urban interface housing growth during the 1990s in California, Oregon, and Washington. Int J Wildland Fire 16:255–265. https://doi.org/10.1071/WF05077

    Article  Google Scholar 

  3. Jolly WM, Cochrane MA, Freeborn PH, Holden ZA, Brown TJ, Williamson GJ, Bowman DM (2015) Climate-induced variations in global wildfire danger from 1979 to 2013. Nat Commun 6:7537. https://doi.org/10.1038/ncomms8537

    Article  Google Scholar 

  4. Blanchi R, Maranghides A, England JR (2020) Lessons learnt from post-fire surveys and investigations. In: Manzello SL (ed) Encyclopedia of Wildfires and Wildland-Urban Interface (WUI) fires. Springer, Cham, pp 743–756

    Chapter  Google Scholar 

  5. Mell WE, Manzello SL, Maranghides A, Butry D, Rehm RG (2010) The wildland-urban interface fire problem—current approaches and research needs. Int J Wildland Fire 19:238–251. https://doi.org/10.1071/WF07131

    Article  Google Scholar 

  6. Fernandez-Pello AC (2017) Wildland fire spot ignition by sparks and firebrands. Fire Saf J 91:2–10. https://doi.org/10.1016/j.firesaf.2017.04.040

    Article  Google Scholar 

  7. Ganteaume A, Lampin-Maillet C, Guijarro M, Hernando C, Jappiot M, Fonturbel T, Perez-Gorostiaga P, Vega JA (2009) Spot fires: fuel bed flammability and capability of firebrands to ignite fuel beds. Int J Wildland Fire 18:951–969. https://doi.org/10.1071/WF07111

    Article  Google Scholar 

  8. Manzello SL, Park SH, Cleary TG (2009) Investigation on the ability of glowing firebrands deposited within crevices to ignite common building materials. Fire Saf J 44:894–900. https://doi.org/10.1016/j.firesaf.2009.05.001

    Article  Google Scholar 

  9. Salehizadeh H (2019) Critical ignition conditions of structural materials by cylindrical firebrands. Dissertation, University of Maryland

  10. Wessies SS, Chang MK, Marr KC, Ezekoye OA (2019) Experimental and analytical characterization of firebrand ignition of home insulation materials. Fire Technol 55:1027–1056. https://doi.org/10.1007/s10694-019-00818-8

    Article  Google Scholar 

  11. Ellis PFM (2011) Fuelbed ignition potential and bark morphology explain the notoriety of the eucalypt messmate “stringybark” for intense spotting. Int J Wildland Fire 20:897–907. https://doi.org/10.1071/WF10052

    Article  Google Scholar 

  12. Tarifa C, Del Notario P, Moreno F, Villa A (1967) Transport and combustion of firebrands, instituto nacional de tecnica aeroespacial, Report No. Grants FG-SP-114 and FG-SP-146

  13. Waterman T, Takata A (1969) Laboratory study of ignition of host materials by firebrands, IIT Research Institute, Report No. IITRI-j6142

  14. Lattimer BY, Bearinger E, Wong S, Hodges JL (2022) Evaluation of models and important parameters for firebrand burning. Combust Flame 235: 111619. https://doi.org/10.1016/j.combustflame.2021.111619

    Article  Google Scholar 

  15. Urban JL, Vicariotto M, Dunn-Rankin D, Fernandez-Pello AC (2019) Temperature Measurement of Glowing Embers with Color Pyrometry. Fire Technol 55:1013–1026. https://doi.org/10.1007/s10694-018-0810-3

    Article  Google Scholar 

  16. Kim DK, Sunderland PB (2019) Fire ember pyrometry using a color camera. Fire Saf J 106:88–93. https://doi.org/10.1016/j.firesaf.2019.04.006

    Article  Google Scholar 

  17. Hakes RSP, Salehizadeh H, Weston-Dawkes MJ, Gollner MJ (2019) Thermal characterization of firebrand piles. Fire Saf J 104:34–42. https://doi.org/10.1016/j.firesaf.2018.10.002

    Article  Google Scholar 

  18. Bearinger ED, Hodges JL, Yang F, Rippe CM, Lattimer BY (2020) Localized heat transfer from firebrands to surfaces. Fire Saf J. https://doi.org/10.1016/j.firesaf.2020.103037

    Article  Google Scholar 

  19. Urban JL, Song J, Santamaria S, Fernandez-Pello C (2019) Ignition of a spot smolder in a moist fuel bed by a firebrand. Fire Saf J 108:102833. https://doi.org/10.1016/j.firesaf.2019.102833

    Article  Google Scholar 

  20. Viegas DX, Almeida M, Raposo J, Oliveira R, Viegas CX (2014) Ignition of mediterranean fuel beds by several types of firebrands. Fire Technol 50:61–77. https://doi.org/10.1007/s10694-012-0267-8

    Article  Google Scholar 

  21. Yin P, Liu N, Chen H, Lozano JS, Shan Y (2014) New correlation between ignition time and moisture content for pine needles attacked by firebrands. Fire Technol 50:79–91. https://doi.org/10.1007/s10694-012-0272-y

    Article  Google Scholar 

  22. Puchovsky M, Simeoni A, Han E, Parrow D, Rozen A (2020) The feasibility of protecting residential structures from wildfires using a fixed exterior fire fighting system, E-project-041020-153548

  23. Zhang H, Qiao Y, Chen H, Liu N, Zhang L, Xie X (2020) Experimental study on flaming ignition of pine needles by simulated lightning discharge. Fire Saf J 120:103029. https://doi.org/10.1016/j.firesaf.2020.103029

    Article  Google Scholar 

  24. Suzuki S, Manzello SL (2019) Investigating effect of wind speeds on structural firebrand generation in laboratory scale experiments. Int J Heat Mass Transf 130:135–140. https://doi.org/10.1016/j.ijheatmasstransfer.2018.10.045

    Article  Google Scholar 

  25. Manzello SL, Maranghides A, Mell WE (2007) Firebrand generation from burning vegetation. Int J Wildland Fire 16:458–462. https://doi.org/10.1071/WF06079

    Article  Google Scholar 

  26. Manzello SL, Maranghides A, Shields JR, Mell WE, Hayashi Y, Nii D (2009) Mass and size distribution of firebrands generated from burning Korean pine (Pinus koraiensis) trees. Fire Mater 33:21–31. https://doi.org/10.1002/fam.977

    Article  Google Scholar 

  27. Suzuki S, Manzello SL (2021) Firebrands generated in Shurijo castle fire on October 30th, 2019. Fire Technol 58:777–791. https://doi.org/10.1007/s10694-021-01176-0

    Article  Google Scholar 

  28. Suzuki S, Manzello SL (2018) Characteristics of firebrands collected from actual urban fires. Fire Technol 54:1533–1546. https://doi.org/10.1007/s10694-018-0751-x

    Article  Google Scholar 

  29. Wang S, Huang X, Chen H, Liu N (2017) Interaction between flaming and smouldering in hot-particle ignition of forest fuels and effects of moisture and wind. Int J Wildland Fire 26:71–81. https://doi.org/10.1071/WF16096

    Article  Google Scholar 

  30. Fang W, Peng Z, Chen H (2021) Ignition of pine needle fuel bed by the coupled effects of a hot metal particle and thermal radiation. Proc Combust Inst 38:5101–5108. https://doi.org/10.1016/j.proci.2020.05.032

    Article  Google Scholar 

  31. Rein G (2016) Smoldering combustion. In: Hurley MJ, Gottuk D, Hall JR, Harada K, Kuligowski E, Puchovsky M, Torero J, Watts JM, Wieczorek C (eds) SFPE handbook of fire protection engineering. Springer, New York, pp 581–603

    Chapter  Google Scholar 

  32. Wang S, Huang X, Chen H, Liu N, Rein G (2015) Ignition of low-density expandable polystyrene foam by a hot particle. Combust Flame 162:4112–4118. https://doi.org/10.1016/j.combustflame.2015.08.017

    Article  Google Scholar 

  33. Ellis PF (2000) The aerodynamic and combustion characteristics of eucalypt bark : a firebrand study. Dissertation, Australian National University

  34. Lin S, Sun P, Huang X (2019) Can peat soil support a flaming wildfire? Int J Wildland Fire 28:601–613. https://doi.org/10.1071/WF19018

    Article  Google Scholar 

  35. Quintiere JG (2006) Fundamentals of fire phenomena. Wiley, Chichester

    Book  Google Scholar 

  36. Sardoy N, Consalvi JL, Porterie B, Fernandez-Pello AC (2007) Modeling transport and combustion of firebrands from burning trees. Combust Flame 150:151–169. https://doi.org/10.1016/j.combustflame.2007.04.008

    Article  Google Scholar 

  37. Galloway TR, Sage BH (1968) Thermal and material transfer from spheres: Prediction of local transport. Int. J. Heat Mass Transf 11:539–549. https://doi.org/10.1016/0017-9310(68)90095-1

    Article  Google Scholar 

  38. Turns SR (2012) An Introduction to Combustion: Concepts and Applications. New York

  39. Consalvi JL, Nmira F, Fuentes A, Mindykowski P, Porterie B (2011) Numerical study of piloted ignition of forest fuel layer. Proceedings of the Combustion Institute 33:2641–48. https://doi.org/10.1016/j.proci.2010.06.025

  40. Tihay V, Simeoni A, Santoni PA, Rossi L, Garo JP, Vantelon JP (2009) Experimental study of laminar flames obtained by the homogenization of three forest fuels. Int J Therm Sci 48:488–501. https://doi.org/10.1016/j.ijthermalsci.2008.03.018

Download references

Acknowledgements

This research was supported by the National Key R&D Program of China (Grant Number: 2022YFC3003100).

Author information

Authors and Affiliations

Authors

Corresponding author

Correspondence to Haixiang Chen.

Ethics declarations

Competing Interests

The authors declare that they have no known competing financial interests or personal relationships that could have appeared to influence the work reported in this paper.

Additional information

Publisher's Note

Springer Nature remains neutral with regard to jurisdictional claims in published maps and institutional affiliations.

Rights and permissions

Springer Nature or its licensor (e.g. a society or other partner) holds exclusive rights to this article under a publishing agreement with the author(s) or other rightsholder(s); author self-archiving of the accepted manuscript version of this article is solely governed by the terms of such publishing agreement and applicable law.

Reprints and permissions

About this article

Check for updates. Verify currency and authenticity via CrossMark

Cite this article

Fang, W., Yang, J., Chen, H. et al. Effect of Wind Velocity on Smoldering Ignition of Moist Pine Needles by a Glowing Firebrand. Fire Technol 60, 501–517 (2024). https://doi.org/10.1007/s10694-023-01520-6

Download citation

  • Received:

  • Accepted:

  • Published:

  • Issue Date:

  • DOI: https://doi.org/10.1007/s10694-023-01520-6

Keywords

Navigation