Abstract
The strength reduction method (SRM) based on the generalized Hoek‒Brown (GHB) criterion has become an important and popular topic to analyse the stability of rock slopes. Various reduction strategies have been proposed and applied by the civil and mining engineering community. This paper proposed a new SRM for rock slopes with the GHB criterion based on the critical failure state curve (CFSC). The existence of the CFSC has been proven by theoretical analysis, and the explicit expression of the CFSCs for different parameters mi and slope angles β, considering the influence of disturbance factor D, has been obtained by curve fitting based on a great deal of simulation data. The new SRM provides a graphic method to determine the parameters at the critical failure state from the initial state by reducing the compressive strength of intact rock σci and the parameter combination sα with the same ratio and proposes a definition of the factor of safety (FOS) based on the parameters of the two states. This method was applied to nine slope examples to verify its validity and accuracy. The relative errors between the critical state parameters obtained from the graphic method and that from the simulation analysis are less than 10%, which proves the accuracy of the CFSCs. The FOSs obtained by the proposed definition are compared with those obtained by the Bishop simplified method and the local linearization method (LLM), and the results are very close. The relative error is less than ± 5% compared with the LLM, and the stability state predicted is perfectly accurate. However, the calculation procedure is largely simplified, and the calculation speed is largely improved. A practical case of an open pit limestone slope with multiple steps was detailed analysed by the proposed SRM based on CFSC. The FOS results comparison with other existing method has demonstrated its feasibility and reliability in engineering application.
This is a preview of subscription content, log in via an institution to check access.
Similar content being viewed by others
Data availability
All data needed for the study have been provided in the paper, and no other data is required.
References
Balmer G (1952) A general analytical solution for Mohr’s envelope. American Society Test Mater 52:1269–1271
Du SG (2018) Method of equal accuracy assessment for the stability analysis of large open-pit mine slopes. Chin J Rock Mech Eng 37(06):1301–1331
Fu WX, Liao Y (2010) Non-linear shear strength reduction technique in slope stability calculation. Comput Geotech 37(3):288–298. https://doi.org/10.1016/j.compgeo.2009.11.002
Hammah RE, Yacoub TE, Corkum B, et al (2005) The shear strength reduction method for the generalized Hoek-Brown criterion. Proceedings of the 40th US Symposium on Rock Mechanics. Alaska Rocks 2005, Anchorage. Alaska.
Han LQ, Wu SC, Li ZP (2016) Study of non-proportional strength reduction method based on Hoek-Brown failure criterion. Rock Soil Mech 37(A2):690–696. https://doi.org/10.16285/j.rsm.2016.S2.088
Hoek E, Brown ET (1980) Empirical strength criterion for rock masses. J Geotech Eng Div 106(GT9):1013–1035
Hoek E, Brown ET (2019) The Hoek-Brown failure criterion and GSI – 2018 edition. J Rock Mech Geotech Eng 11(3):445–463. https://doi.org/10.1016/j.jrmge.2018.08.001
Hoek E, Carranza-Torres CT, Corkum B (2002) Hoek-Brown failure criterion-2002 edition. In: Proceedings of the Fifth North American Rock Mechanics Symposium (NARMS-TAC), University of Toronto Press, Toronto: 267–273
Krahn J (2007) Limit equilibrium, strength summation and strength reduction methods for assessing slope stability. Int J Life Cycle Assess 14(2):175–183. https://doi.org/10.1201/noe0415444019-c38
Li AJ, Merifield RS, Lyamin AV (2008) Stability charts for rock slopes based on the Hoek-Brown failure criterion. Int J Rock Mech Min Sci 45(5):689–700. https://doi.org/10.1016/j.ijrmms.2007.08.010
Li AJ, Merifield RS, Lyamin AV (2011) Effect of rock mass disturbance on the stability of rock slopes using the Hoek-Brown failure criterion. Comput Geotech 38(4):546–558. https://doi.org/10.1016/j.compgeo.2011.03.003
Liu SY, Shao LT, Li HJ (2015) Slope stability analysis using the limit equilibrium method and two finite element methods. Comput Geotech 63:291–298. https://doi.org/10.1016/j.compgeo.2014.10.008
Melkoumian N, Priest SD, Hunt SP (2009) Further development of the three-dimensional Hoek-Brown yield Criterion. Rock Mech Rock Eng 42(6):835–847. https://doi.org/10.1007/s00603-008-0022-0
Priest SD (2005) Determination of shear strength and three-dimensional yield strength for the Hoek-Brown criterion. Rock Mech Rock Eng 38(4):299–327. https://doi.org/10.1007/s00603-005-0056-5
Russo G (2008) A new rational method for calculating the GSI. Tunn Undergr Space Technol 24(1):103–111. https://doi.org/10.1016/j.tust.2008.03.002
Sari M (2019) Stability analysis of cut slopes using empirical, kinematical, numerical and limit equilibrium methods: case of old Jeddah-Mecca road (Saudi Arabia). Environ Earth Sci 78(21):621. https://doi.org/10.1007/s12665-019-8573-9
Shen JY, Karakus M (2014) Three-dimensional numerical analysis for rock slope stability using shear strength reduction method. Can Geotech J 51(2):164–172. https://doi.org/10.1139/cgj-2013-0191
Shen JY, Karakus M, Xu CS (2012) Direct expressions for linearization of shear strength envelopes given by the Generalized Hoek-Brown criterion using genetic programming. Comput Geotech 44:139–146. https://doi.org/10.1016/j.compgeo.2012.04.008
Shen JY, Karakus M, Xu CS (2013) Chart-based slope stability assessment using the generalized Hoek-Brown criterion. Int J Rock Mech Min Sci 64:210–219. https://doi.org/10.1016/j.ijrmms.2013.09.002
Song K, Yan EC, Mao W et al (2012) Determination of shear strength reduction factor for generalized Hoek-Brown criterion. Chin J Rock Mech Eng 31(1):106–112
Sukanya C, Heinz K, Katrin W (2012) A comparative study of different approaches for factor of safety calculations by shear strength reduction technique for non-linear Hoek-Brown failure criterion. Geotech Geol Eng 30(4):925–934. https://doi.org/10.1007/s10706-012-9517-2
Sun CW, Chai JR, Xu ZG et al (2016) Stability charts for rock mass slopes based on the Hoek-Brown strength reduction technique. Eng Geol 214:94–106. https://doi.org/10.1016/j.enggeo.2016.09.017
Thomas B, Radu S, Regina AK et al (2008) A Hoek-Brown criterion with intrinsic material strength factorization. Int J Rock Mech Min Sci 45(2):210–222. https://doi.org/10.1016/j.ijrmms.2007.05.003
Wei YF, Fu WX, Ye F (2021) Estimation of the equivalent Mohr-Coulomb parameters using the Hoek-Brown criterion and its application in slope analysis. Eur J Environ Civ Eng 25(4):599–617. https://doi.org/10.1080/19648189.2018.1538904
Wu SC, Jin AB, Gao YT (2006) Numerical simulation analysis on strength reduction for slope of jointed rock masses based on generalized Hoek-Brown failure criterion. Chin J Geotech Eng 28(11):1975–1980
Xu JS, Yang XL (2018) Seismic stability analysis and charts of a 3D rock slope in Hoek-Brown media. Int J Rock Mech Min Sci 112:64–76. https://doi.org/10.1016/j.ijrmms.2018.10.005
Yang XL, Yin JH (2010) Slope equivalent Mohr-Coulomb strength parameters for rock masses satisfying the Hoek-Brown criterion. Rock Mech Rock Eng 43(4):505–511. https://doi.org/10.1007/s00603-009-0044-2
Yuan W, Li JX, Li ZH et al (2020) A strength reduction method based on the generalized Hoek-Brown (GHB) criterion for rock slope stability analysis. Comput Geotech 117:103240. https://doi.org/10.1016/j.compgeo.2019.103240
Zhang WL, Sun XY, Chen Y (2022) Slope stability analysis method based on compressive strength reduction of rock mass. Rock Soil Mech 43(S2):607–615. https://doi.org/10.16285/j.rsm.2021.0170
Zhao SY, Zheng YR, Shi WM, Wang JL (2002) Analysis on safety factor of slope by strength reduction FEM. Chin J Geotech Eng 24(3):343–346
Zhao SY, Zheng YR, Zhang YF (2005) Study on slope failure criterion in strength reduction finite element method. Rock Soil Mech 26(2):332–336. https://doi.org/10.16285/j.rsm.2005.02.035
Zong QB, Xu WY (2008) Stability analysis of excavating rock slope using generalized Hoek-Brown failure criterion. Rock Soil Mech 29(11):3071–3076. https://doi.org/10.16285/j.rsm.2008.11.037
Acknowledgements
This research was funded by the S&T Program of Hebei Province, China (No. 22375413D). The authors gratefully acknowledge the research support of the Hebei Technology and Innovation Center on Safe and Efficient Mining of Metal Mines.
Author information
Authors and Affiliations
Contributions
All authors contributed to the study. The first draft of the manuscript was written by Wenlian Zhang and all authors commented on previous versions of the manuscript. The study design and conception were provided by Xiaoyun Sun and Wei Yuan. The model design, data simulation and analysis were performed by Wenlian Zhang. Ting Liu and Shenyi Jin completed some simulation and figures preparation. All authors read and approved the final manuscript.
Corresponding author
Ethics declarations
Conflict of interest
The authors have no competing interests as defined by Springer, or other interests that might be perceived to influence the results and/or discussion reported in this paper.
Additional information
Publisher's Note
Springer Nature remains neutral with regard to jurisdictional claims in published maps and institutional affiliations.
Supplementary Information
Below is the link to the electronic supplementary material.
Rights and permissions
Springer Nature or its licensor (e.g. a society or other partner) holds exclusive rights to this article under a publishing agreement with the author(s) or other rightsholder(s); author self-archiving of the accepted manuscript version of this article is solely governed by the terms of such publishing agreement and applicable law.
About this article
Cite this article
Zhang, W., Sun, X., Yuan, W. et al. Rock slope stability assessment based on the critical failure state curve for the generalized Hoek‒Brown criterion. Environ Earth Sci 83, 168 (2024). https://doi.org/10.1007/s12665-024-11485-6
Received:
Accepted:
Published:
DOI: https://doi.org/10.1007/s12665-024-11485-6